- Codejock report control row highlighting serial number#
- Codejock report control row highlighting install#
- Codejock report control row highlighting software#
- Codejock report control row highlighting mac#
Change the HDD or add it in case of lacking in capacity. Confirm the total capacity of the HDD if it is more than 320GB. If an error is detected after executing U024, replace the HDD. Execute U024 to initialize (FULL) the HDD. Check the SATA wiring between the HDD and the main circuit PWB for loose connection, disconnection and damages, and that it is connected into the correct terminal. If an abnormal noise is heard from the HDD, replace the HDD. Description: Hard disk error The hard disk cannot be accessed.Wiring that connects the DP main PWB and the main PWB. Wiring that connects the CIS and the DP controller PWB. If the wiring is disconnected, shorted or grounded, replace the wiring. HDD 1piece: Single HDD 2pieces: Multied and, if necessary, connect the connector all the way in. Confirm whether the HDD number is correct in U024_Composition and change it if different. Confirm that the wiring connector is firmly connectHDD number difference 1. If the wiring is disconnected, shorted or grounded, replace the wiring.ĭP main PWB Main PWB 1. Confirm that the CIS connector terminals are firmly connected. Description: DMA error DMA transmission of image data does not complete within the specified period of time.Check the FAX image DIMM terminals and remove any foreign objects that may be adhered to it.
Codejock report control row highlighting install#
Firmly install the FAX image DIMM again onto the main board. Install the FAX image DIMM supplied in the FAX system onto the main PWB. The Fax image DIMM has not been installed. Operation PWB (YC10) and Main PWB (YC6) 3. Confirm that the wiring connector is firmly connected and, if necessary, connect the connector all the way in. Turn the main power swtch off and after 5 seconds, then turn power on.
Codejock report control row highlighting serial number#
If the serial number data of different models is alternately displayed, install the correct EEPROM in the PWB of the wrong serial number data. Confirm the machine data for the main and engine units by using U004. Description: Machine number mismatch Machine number of main and engine does not match.If the EEPROM data are currupted, contact the service support. Check that the EEPROMs installed in the main PWB and the engine PWB are correct and, if not, use the correct EEPROM for the model. Description: Billing counting error The values on the main circuit PWB and on the engine do not match for any of charging counter, life counter, and scanner counter.If the EEPROM data are currupted, contact the service support Execute U021 - memory initializing.(see page 1-3-28) 3. Description: Backup memory data error (engine PWB) Reading data from EEPROM is abnormal.Check the EEPROM and if the data are currupted, contact the service support. Check that the EEPROM is peroperly installed on the engine PWB and reinstall it. Mismatch between writing data and reading data occurs 8 times successively. Mismatch of reading data from 2 locations occurs 8 times successively. Description: Backup memory read/write error (engine PWB) No response is issued from the device in reading/writing for 5 ms or more and this problem is repeated 5 times successively.
Codejock report control row highlighting mac#
If it is blank, obtain an EEPROM with its MAC address written from the service support and install. Check the MAC address on the network status page.
Codejock report control row highlighting software#
Description: FAX control PWB system error Processing with the fax software was disabled due to a software problem.